src/r8168.ko speed=SPEED_MODE duplex=DUPLEX_MODE autoneg=NWAY_OPTION ![]() To one of the 5 modes as following command. If the user is in the path ~/r8168, the link status can be forced Force the link status when insert the driver. # ip link set ethX address YY:YY:YY:YY:YY:YYġ. YY:YY:YY:YY:YY:YY is the MAC address assigned by the user. ,where X is the device number assigned by Linux kernel, and # ifconfig ethX hw ether YY:YY:YY:YY:YY:YY There are two ways to modify the MAC address of the NIC. ifcfg-ethX for Redhat and Fedora, or /etc/sysconfig/network ![]() Set by doing configurations in /etc/sysconfig/network-scripts # route add default gw "the IP address of gateway"Ģ. Insert the following configuration in /etc/nf. # ifconfig ethX "the IP address of your machine" Then, you can use the following command to activate If there is a device name, ethX, shown on the monitor, the linuxĭriver is loaded. You can check whether the driver is loaded by using following commands. ![]() If you are running the target kernel, then you should be able to do : Compiler/binutils for kernel compilation For linux kernel 2.4.x, this driver supports 2.4.20 and latter. Kernel source tree (supported Linux kernel 2.6.x and 2.4.x) This is the Linux device driver released for RealTek RTL8168B/8111B, RTL8168C/8111C, RTL8168CP/8111CP, RTL8168D/8111D, RTL8168DP/8111DP, and RTL8168E/8111E Gigabit Ethernet controllers with PCI-Express interface.
0 Comments
Leave a Reply. |